symptom

Possible problems and solutions

Normal key, not the reader;

Beep sound when opened eight lockout ...

Lack of direct current, controller failure;

It is necessary to increase a DC power supply to the electric lock power supply or replace

Reset the card after the effective power increase

Key Normal,

Reading distance near or insensitive reader

1.    The controller placed on a metal surface;

Adjust the position of Controller

2.    Current supply shortage;

Adjust Power

After the reader toot, toot, do not unlock

1 . Set up Card + PIN mode;

Enter the password to open the door or adjustment

2 . Before the reader is pressed [ # ] key;

Wait 5 seconds later to reader

Valid card beep does not unlock

Magnetic detection is provided unlocked state, then there is no door sensor or the door is not closed;

Magnetic detection of the closed state or the unlocked closed door sensor

[*] + [ Programming password ] halfway beep sounding, did not enter the programming mode

Press [*] before button, press the other keys;

Press and hold the [* ] key press after a long beep [*] + [ programming password ] to

[ # ] Key, beep, can not modify the personal password

Press [ # ] before button, press the other keys;

Press and hold the [ # ] key, appears a long beep, press [ # ] to

Press [5] , 3 beeps

The controller card capacity is full

[5] + [ encoding ] , toot toot

This encoding has been used;

To be re [5] + [3 -bit code ] Operation

[5] + [ encoding ] beeps + [ induction card ] toot toot

The card has been set to a valid card;

This coding can also be used for other cards

The programmed state, no operation, the controller exits the programming state

In programming mode, if 20 within seconds, without any programming instructions, the system exits automatically programmed into the normal working state.

DOOR

Magnetic pick

The other end DGND

DGND

POENSW

Then open button

The other end DGND

PUSH/NO

Negative electrical unlocking stage ON

The other end of the electric lock

＋12VDC

NC

Take power lock negative level

The other end of the electric lock

＋12VDC

GND

DC power source connected to ground

+12VDC

Positive DC power supply connected

BELL

Then the doorbell

BELL

Then the doorbell

JP3 jumper

Installation and connection

JP2 jumper

Connector 1 , 2 feet

DOOR

Magnetic pick

The other end DGND

DGND

POENSW

Then open button

The other end DGND

PUSH/NO

Access the power connection PUSH

Control Power electric lock connected in connection

NC

GND

DC power source connected to ground

+12VDC

Positive DC power supply connected

BELL

Then the doorbell

BELL

Then the doorbell

JP3 jumper

Withdrawn, disconnected

JP2 jumper

Connection 2 , 3 feet